Dynisco 1390-2-3 Temperature Indicator

Tại Việt Nam, Hãy liên hệ với chúng tôi nếu Quý khách cần báo giá chính hãng hoặc tài liệu catalogue, datasheet, manual, bản vẽ, hướng dẫn sử dụng sửa chữa thiết bị Dynisco 1390-2-3 Temperature Indicator350 ohm strain gage inputPushbutton programming and calibrationConfigwareâ„¢ SW configurableScalable, voltage or current outputsMODbus communication optionPeak and valley detectionTransducer interrupt detectionUL, cUL recognizedCE approvedSpecifications Performance Characteristics Instrument type: Digital panel meter Display: 5 red LED digits 0.5″ (12.7mm) high 2 red LED lights for alarm 1 green LED light for remote configuration Accuracy: ±0.1% Normal Mode Rejection Ratio: 60dB at 50/60Hz Sampling Time: 100mS Input Thermocouple: Types J, K, E, L, N, R, S, T RTD: Type PT100 (DIN 43760) Linear Input: 0(4)-20mA and 0(1)-5Vdc and 0(2)-10Vdc Scaling: ?F or ?C programmable Alarm Outputs (2) Alarm Type: Two SPST Form C Contact Rating: 0.6A @110Vdc, resistive load 0.5A @220Vdc, resistive load 0.3A @110Vdc, inductive load Alarm Update Time: 100mS Analog Retransmission Outputs Type: 0(4)-20mA, 0(1)-5V or 0(2)-10V. 500?, max load Resolution: ±0.05% of output span maximum Accuracy: ±0.2% of span Update Time: 100mS Serial Communication Interface Type: Isolated RS-485 Protocol: ModBus/JBus selectable (half duplex) Baud Rate: 150 – 19200 baud Format: 8 bits + parity; 8 bits without parity Parity: Odd / Even Mechanical & Packaging Characteristics Termination: Screw terminals on rear with safety covers Front Panel: IP65/NEMA4-rated with gasket Operating Temperatures: 32? – 130?F (0? – 55?C) Humidity: 5 – 85% relative humidity, non-condensing Vibration: 10 – 150Hz at a peak of 1G Approvals & Certifications CE Mark: EMC standard EN 61326-1 2002 Safety standard EN 61010-1 2001 Agency approvals: UL: According to UL 3121-1 cUL: According to C22.2 No. 142 C-Tick: Australia Power Supply (Mains) Input Power: 85-264 Vac (24V ac/dc available) Power Consumption: 10W, max Input Protection: Internal thermistor Isolation: Reinforced isolation from instrument and all other I/O circuits